Technical Specifications

Product Instructions

1. Before powering on, check the stored and transported switch power supply. Inspect for any damage during transportation, such as loose screws, abnormal appearance, disconnected or shaken power cords and terminals, or signs of dampness. If any of these are found, address them promptly.
2. The local power switch controls the auxiliary power supply inside the machine. For safety reasons, please add an air switch at the power input terminal to control the main input. Connect the ground wire and input power wire according to the labels on the rear panel, verifying correct installation. Ensure that the input power voltage matches the specifications indicated in the manual.
3. The cooling fan features temperature-controlled operation. The fan activates when the internal temperature exceeds the starting threshold. The fan speed will vary dynamically based on the output voltage and current, which is normal. Ensure that the inlet and outlet vents of the fan are kept clear of obstructions at all times.
4. When the internal temperature of the device reaches the overheating safety threshold, the machine will shut down automatically to prevent damage. Once the temperature drops to a safe level, it will resume operation automatically.
5. When operating the power equipment, ensure the surrounding air does not contain excessive dust, acid, or corrosive gases. Avoid exposure to severe vibrations, impacts, rain, and direct sunlight.
6. Regular dust removal is recommended to significantly extend the service life and reliability of the equipment. Dry compressed air can be used for dust removal. *Warning:* High voltage is present inside; do not open the casing or risk damaging internal components.
7. If the power equipment is left idle for extended periods, store it in a dry and well-ventilated room. If stored for more than 6 months, the equipment should be powered on and run for at least half an hour before use.
8. Warning: Only connect your electrical load to the system after the initial power-on test runs successfully without errors.
9. Troubleshooting & Support: If you observe any abnormal operation after powering on the device, shut off the power switch of the stabilized power supply immediately. Check the correctness of all external and internal connections, verify that all terminal screws are tight, and ensure all switches and knobs are positioned correctly. If problems persist, do not attempt to open the casing or disassemble components yourself, as dangerous high voltage is present inside. Please notify technical service promptly to resolve the issue.